Braided fleece leashes are gentle for training puppies.
Braided fleece dog leashes are soft to the touch and allow your pet to tug or pull with less discomfort to his neck. Fleece stretches slightly to absorb shock as a dog pulls forward on a leash. This results in less stress on his collar and your hands and arms as you walk or train your pet. Braiding the fleece strips together adds strength to the leash.
2 yards fleece material
Metal swivel snap
1 foot twine
Colored duct tape
- Lay the fleece material out on a flat surface. Measure 2 inches from the edge on one short side of the material and mark it with a pencil. Open a tape measure and extend the tip across the length of material. Lock the tape measure and set it down on the material at the 2-inch marking. Place a pencil next to the tape measure and draw a line down the 2-yard length of material. Cut the 2-yard by 2-inch wide strip of fabric with scissors. Repeat this step to cut two additional strips of fabric in the same size.
2. Hold the metal swivel snap in one hand. Fold one strip of fleece in half lengthwise. Hold the fold behind the swivel snap eye in a loop and thread both ends through the loop. Pull both ends tightly to form a lark’s head knot. Repeat this to attach the additional two strips. You will end up with three sets of two pieces of material hanging from the swivel snap.
3. Anchor the swivel snap to a solid surface by clipping it to an object or use duct tape to hold it steady. Grasp the left set of two strips and cross them over the center set of two. Grasp the right set of two strips and cross them over the center set of two to form a braid. Continue this sequence until you have 2 inches of non-braided material. Keep tension on the fabric as you braid.
4. Make a loop in the unbraided material with all six strands. Pass the loose ends through the loop and pull all the loose ends tight to tie a knot securing them in place.
5. Cut a 1-foot length of twine with scissors. Hold the knot on the end of the leash next to the length of leash to form a loop about 6 inches around for the handle. Place one end of the twine about 2 inches below the knot on the leash portion and hold it in place with one hand. Use your other hand to twist the twine in a circular motion over the leash, the leash and handle junction and about 2 inches past the knot. Loop the loose end of the twine through the second to last revolution around the leash and pull it tight. Cut off any excess length.
6. Cut a strip of colored duct tape about 6 inches long. Wrap the tape tightly around the twine to cover it from sight and secure the handle.